+1 440.834.5400
Duramax Marine
.
Johnson Cutless
Water-Lubricated
Bearing Systems,
Rudder Bearings and Stern Tube Filler
.
Advanced
Water-Lubricated Strut, Stern Tube and Rudder Bearing Systems
.
Duramax Heat
Exchange Systems
.
Duramax Shaft
Seal Systems
.
Duramax Impact
Protection Systems
.
Duramax
Industrial Products
.

Request For Heat Exchanger Quote


Instructions for requesting a quotation:
1. Complete the items shown in bold on the sizing sheet.
This will enable Duramax Marine® to determine the correct Cooler for your application.

2. If the information shown in "non-bold" is available,
it may permit Duramax Marine® to quote a less expensive Cooler. Please provide as much of this information as possible.


  Select a Cooling System you are interested in:
DuraCooler
Demountable
BoxCooler
Plate Heat Exchanger
 GENERAL INFORMATION
   
*Company Name:
*Contact Name:
*Email:
Address:
City:
State:
Zip:
Country:
Phone:
Fax:
Vessel Name/Hull#:
New Construction:
Yes  No/Retrofit
Type/Use of Vessel:
Dimensions (feet):
length:  beam:  draft:
Preferred Cooler: 
Single Pass Double Pass Quad Pass
* indicates a field is required


 
 MAIN ENGINE INFORMATION
   
Manufacturer:
Model Number:
Quantity:
Min. Speed at which full HP will be developed:
Knots
Model Year of Engine:
HP: @RPM:
Total Heat Rejection:
BTU/Min 
Coolant Temp to Engine:
Pump Flow Rate/Range:
GPM / To Cooler:
Exhaust:
Wet   Dry   N/A
Aftercooler Circuit:
Separate    Combined
Attachment Method to Hull:
Flanged Nozzle     Inlet/Outlet
Manufacturer of Gear
(if cooled by DuraCooler):
If Reintjes gear, provide water pump flow:
GPM
System pressure drop requirements:


 EXTERNAL CONDITIONS
   
Minimum Vessel Speed at Full Power :
knots
Maximum Ambient Sea Water Temp:
Location of Coolers:
Bottom    Side of Hull
Are there space restrictions on the hull?
Yes     No
If "Yes", list size restrictions:






DuraCooler app
 
 GENERATOR
   
Manufacturer:
Model Number:
Quantity:
Model Year of Engine:
   HP   KW  
Engine RPM:
Attachment Method to Hull:
Flanged Nozzle    Inlet/Outlet
System pressure drop requirements:
(will be sized for 0 knots unless otherwise directed.)

   


 OTHER (Pump, Thruster, Compressor, etc.)
   
Type:
Manufacturer:
Model Number:
Quantity:
Model Year of Engine:
   HP   KW  
Engine RPM:
Attachment Method to Hull:
Flanged Nozzle    Inlet/Outlet
System pressure drop requirements:
(will be sized for 0 knots unless otherwise directed.)

   


 PLEASE REVIEW ALL FORM FIELDS THEN SUBMIT
 
 
LOADING PLEASE WAIT
 
DuraCooler® is a registered trademark of Duramax Marine® LLC.




17990 Great Lakes Parkway, Hiram, Ohio 44234 U.S.A.  |  PHONE +1 440.834.5400  |  FAX +1 800.497.9283 USA & Canada or +1 440.834.4950 
Home | Literature | SITEMAP